Exposed Aggregate Driveway Installation in Brisbane

As a ballpark figure, expect approximately $160–$180 per m² supplied and installed. The final rate depends on the aggregate and finish, total area, access, excavation, preparation and drainage, so we confirm it with a site-specific quote.

Allow about 3–5 working days for a typical residential exposed aggregate driveway, including preparation, pouring, surface exposure, washing and sealing. Light foot traffic is usually possible after 24–48 hours, while vehicles should stay off for at least 7 days unless we provide a different site-specific timeframe.

It is durable, slip-resistant, low maintenance and available in many attractive finishes.

Yes. With correct installation, curing and sealing, exposed aggregate can perform well for many years.

We prepare and form the site, place the aggregate concrete mix, apply a surface retarder, expose the aggregate at the correct time, clean the surface and seal it after curing.